I need to replace the return shock cord on the Hawaiian style of righting system that I have on my H16 and would like some suggestions about what size shock cord should be used. The cord that is currently installed seems a bit small and needs to be replaced. Thanks for any suggestions.

--
Marty
1984 Hobie 16 Redline Yellow Nationals, "Yellow Fever"
Opelika, Al / Lake Martin
--

1/4" minimum, 3/8" if it will run in the blocks involved.

--
Sheet In!
Bob
_/)_____/)_/)____/)____/)_____/)/)__________/)__
Prindle 18-2 #244 "Wakizashi"
Prindle 16 #3690 "Pegasus" Sold (sigh)
AZ Multihull Fleet 42 member
(Way) Past Commodore of Prindle Fleet 14
Arizona, USA
--

Thank you. I think the one I have is 1/4" because it looks very thin. I discovered that at the rear block it had frayed and is barely hanging on by a couple of rubber bands. I think I would go with the thicker stuff for sure.

--
Marty
1984 Hobie 16 Redline Yellow Nationals, "Yellow Fever"
Opelika, Al / Lake Martin
--

Look for Marine Grade bungee.
It will last longer than the cheap imported stuff.

--
Sheet In!
Bob
_/)_____/)_/)____/)____/)_____/)/)__________/)__
Prindle 18-2 #244 "Wakizashi"
Prindle 16 #3690 "Pegasus" Sold (sigh)
AZ Multihull Fleet 42 member
(Way) Past Commodore of Prindle Fleet 14
Arizona, USA
--

Thanks, I will keep that in mind.

--
Marty
1984 Hobie 16 Redline Yellow Nationals, "Yellow Fever"
Opelika, Al / Lake Martin
--