[quote=Wolfman]Almost all rudder pins are 3/8" diameter except he H20 (and maybe a couple of the newer boats). I think the Murray's ones are actually hollow.
I have a drill press (and a whole garage of woodworking tools). Shouldn't be a problem drilling the hole, that and the alloy is 303, which is easier to cut and drill than 304.
I had the same problem on my lake with our old hobie 16, the mast is 28 feet long and the lake is only 8-10 feet deep. I haven't have that problem with the N 5.2 simply because the mast volume is large and I sealed the heck out of it.
When I was a kid I remember sticking the hobie mast over 6 feet into the muck. It took hours and hours to unstick, finally a ski boat got us out but we were scared the mast was going to break.
I haven't gotten to a post office yet but I should send your package off on Monday. We've been deluged here with record rain (I have about an inch of water in my basement). If you want a set I can probably cut them and send fire them into the box, not sure if I will have time to drill them.
D.
[/quote]
No HTML tags allowed (except inside [code][/code] tags)
