[quote=waylerindy78]I made a 6-7' high critch from 2x4, with tripod base this way the mast is at 20-25 pitch at the start of the raise and likewise when lowering it on my Hobie 20, also have used a 7' vertical strut at base of mast w roller on top, stru straps to striker, mid point front crossbeam, on a few occasions have raised my H Miracle 20 mast solo with trap lines used to prevent sideways motion, the H 20 mast is very heavy, 31' approx 60 lbs
[quote=dennisMe]I own a Nacra 5.2 and usually raise and lower the mast solo.
I rig up a double turning block to the bridle. A long (30') line goes from the bridle apex to the forestay where it runs over another turning block, then back through the bridle turning block and to a cleat on the main beam. I normally use this 2:1 setup to make it easyer to pull on the mast, but I have gone without it a couple of times.
Just hold taught, undo the forestay and any jib halyard that may have been tied to the bridle. Then walk backwards letting out about a foot of line at each step. Once the line starts to stretch grab the mast and lower it down manually. Then before getting off, lower it down onto your shoulders and let it onto a waiting stepladder (about 6-8'high) or a fence (as I do).
Before starting the boat needs to be facing downwind (or in a sheltered spot) so the wind helps keep the mast up!
This is what I do, and it always a little intimidating to start, but works every time.
Dennis[/quote][/quote]
No HTML tags allowed (except inside [code][/code] tags)
