[quote=martyr]Yes, it is advised that when using these for securing the frame casting corners that you tighten them until they are snug. If you really torque down on them then you run the risk of cracking the corner casting, and that will be somewhat of an expensive "ouch".
You have to keep in mind that cast aluminum is not going have much flex and will crack under stress. Now I feel as though I should just stick with the "fail safe" original nylon nuts because it would be just my luck that I would probably over tighten the nylocs and crack a corner casting. Lol.[/quote]
No HTML tags allowed (except inside [code][/code] tags)
