All,
The cam blocks on my Harken 8:1 downhaul are sticky so of course they are not doing a great job and downhaul gets loose. Any suggestions on reviving them? Lubricants? Cautions when disassembling?
Thanks
Help for sticky cam blocks
-
- Rank: Mate
- Registered: Sep 05, 2004
- Last visit: Oct 19, 2015
- Posts: 327
Posted: Sep 24, 2009 - 12:43 PM
-
- Rank: Mate
- Registered: Jan 14, 2004
- Last visit: Sep 25, 2024
- Posts: 866
Posted: Sep 24, 2009 - 02:16 PM
This is going to sound overly simple or condescending, but, use high pressure water, and manually exercise/pivot each cleat. That should do it. Also check that the screw going down the center of each cleat is not over tightened (compressed and binding) the cleat from pivoting.
IMO, do NOT use lubricants.
--
Philip
-- -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Dec 04, 2024
- Posts: 7090
Posted: Sep 24, 2009 - 02:46 PM
cam blocks or cleats?
sticky or sticking?
if sticking i agree with Philip,
if sticky, stop lubricating with honey.
if blocks, (although this is more for main blocks) you may need to remove and soak in ultra hot water (not boiling) and soak and repeat. this can free up salts built up.. -
- Rank: Mate
- Registered: Jan 14, 2004
- Last visit: Sep 25, 2024
- Posts: 866
Posted: Sep 24, 2009 - 02:53 PM
To clarify, when I said cleat, I meant cam cleat, as in
http://www.harkenstore.co….showProd?B4RPMEB9Y8VKMG
--
Philip
-- -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Dec 04, 2024
- Posts: 7090
Posted: Sep 24, 2009 - 04:09 PM
I agree, you will only make it easier for lines to slip out.. there are no bearings to lube here.. only a single strip of metal that acts as a spring -
- Rank: Mate
- Registered: Sep 05, 2004
- Last visit: Oct 19, 2015
- Posts: 327
Posted: Sep 27, 2009 - 11:09 AM
Yep..Struggled with calling them cleats or blocks. Looks like I just need to clean and adjust. Thanks
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.