. What do you guys and gals think?--
P16
Lake Wylie, SC
--
2-Part Urethane Foam to repair soft spots?
-
- Rank: Lubber
- Registered: Apr 29, 2009
- Last visit: Jan 22, 2012
- Posts: 3
Posted: Jul 11, 2010 - 02:05 AM
I have an '83 Prindle 16 and the inner side of the port hull from the center of the tramp forward is pretty much a giant soft spot. I was going to use thickened west systems until I discovered the full extent of the soft spot. I have done a good bit of work with composited before and I was thinking of just using a 3 or 4-lb density A B Urethane foam and just inject it similar to how its done with west systems, the only reason I don't want to use west is because of the cost associated with that product . What do you guys and gals think?
--
P16
Lake Wylie, SC
-- -
- Rank: Mate
- Registered: Feb 19, 2008
- Last visit: Aug 26, 2023
- Posts: 671
Posted: Jul 11, 2010 - 06:57 AM
guess it might work for a bit....do and get back to us with the results
-
- Rank: Mate
- Registered: May 30, 2007
- Last visit: Jun 28, 2011
- Posts: 101
Posted: Jul 12, 2010 - 03:55 PM
I would try the traditional penetrating epoxy fix before i used A/B foam. You can get Get-Rot epoxy or a similar penetrating epoxy pretty cheaply. -
- Rank: Lubber
- Registered: Jun 10, 2012
- Last visit: Jul 09, 2013
- Posts: 24
Posted: Jul 05, 2012 - 10:59 AM
Briang, did you do the repair? And if so, what did you use and how?
--
Jeremy Soder
Nacra 5.8
Allen, TX
-- -
- Rank: Chief
- Registered: Jul 16, 2009
- Last visit: Oct 28, 2014
- Posts: 1271
Posted: Jul 05, 2012 - 01:35 PM
standard polyester resin(bondo/3m brand 30$ gallon) works fine for injection. 2 part foam can expand way too much and do more damage than good, it also absorbs water and gets heavier as time passes. injection repairs can be rock solid and last a long time so don't be afraid!
--
Check out "Prindle Sailors" on Facebook!
bill harris
hattiesburg, mississippi
prindle 16- "BLUE RIBBON"
-- -
- Rank: Mate
- Registered: Oct 19, 2006
- Last visit: Aug 16, 2017
- Posts: 613
Posted: Jul 05, 2012 - 05:48 PM
2 ways to do this, you can either take tramp off, separate hulls by removing beams so that you can place hull soft side up and level, which takes a lot more time, or flip entire P16 on its side soft side up and level, leaning it against some sort of support, (tree, side of house), tape delaminated area off with masking tape, and use product as suggested by coastrat. One word of caution, do whatever it takes to make sure you break through outer skin only when drilling holes, penetrating through inner layer just causes all sorts of problems and delays and wastes much resin. 2nd method much quicker and you can be up and sailing again in a couple of days.
--
TurboHobo
H14T
H16
P18
G-Cat 5.0
P16
--
