The upper section of the roller furling forestay is beginning to unwind
I need to remove about 2 inches of it also since to get the rig tight it has to be in the lowest hole
I would like a turnbuckle there to replace it, but I can't find a turnbuckle with exactly the ends I want. I want one end to fit in the upper furler swivel 1/4" thick with 1/4" hole, and one end with large loop to fit on the shackle on the mast with the other stay's. Total length between 7.5 to 9 inches the current one is 9 and 5/8.
Has anyone replaces it with this setup, it seems like I will have much better adjustability
Thanks,
Ernie
--
Ernie Kamp
http://www.youtube.com/user/TopSpin80#g/u
Richmond / Livingston / Galveston / Kemah / Texas City, Texas
Supercat 19 and Blade F16 "Nauti Habit", 2 Sunfish
--
Forestay (Supercat 19)
-
- Rank: Lubber
- Registered: Jul 04, 2004
- Last visit: Sep 29, 2020
- Posts: 26
-
- Rank: Lubber
- Registered: Jul 08, 2005
- Last visit: Aug 26, 2023
- Posts: 97
I've looked here, http://www.suncorstainles…aw-jaw-turnbuckle-w-nuts and I don't see anything that would be what you're looking for. Also might check http://www.mcmaster.com they may have something. Might be easier and safer to get a pigtail made at a marina that does rigging or industrial supply house. Also check with http://www.aquarius-sail.com/, as they were the makers of SC. Good luck.
--
Mike Conway
H16
Hilton, NY
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.