hey everybody. As you know I broke my boom pin on my G-Cat. I have bought a replacement off a different boat and am going to try to make that work. Please take a look at the pics below. As you can see the new shank is pretty long. If it will slide in and out and bang around to much if I install it this way. Any suggestions on how I should do this? Should I bring this to a welder and have him weld it in? Please help!Thank you all :)
G-Cat 5.0 Boom Pin replacement. Check out the pics!
-
- Rank: Lubber
- Registered: Aug 23, 2006
- Last visit: Jul 08, 2011
- Posts: 20
-
- Rank: Administrator
- Registered: Jul 19, 2001
- Last visit: Oct 31, 2024
- Posts: 3445
It looks like the original was riveted on top and bottom, can the new one be attached the same way? It seems to have the same rivet tabs but would have to match size perfectly to work.
--
Damon Linkous
1992 Hobie 18
Memphis, TN
How To Create Your Signature
How To Create Your Own Cool Avatar
How To Display Pictures In The Forums.
-- -
- Rank: Lubber
- Registered: May 22, 2011
- Last visit: Jul 09, 2011
- Posts: 10
Put a sleeve around the pin, the sleeve will be between the back of the plate and where the hole is for the pin (through the boom pin). Sorry i do not have a picture as i have reassembled mine a few weeks ago, sorry. The sleeve should allow a little bit of play but not much, just about 1/4". -
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Oct 20, 2024
- Posts: 878
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.