The line on my cat tracks burned off in a little problem someone had. How are people securing the boat to ends? And where on the boat, ie bow, middle, stern location. I have been rigging it all sorta ways.
Thanks
--
The Bone
H16
Mass / NH
--
Cat trax and all that...
-
- Rank: Lubber
- Registered: Dec 25, 2010
- Last visit: Nov 26, 2011
- Posts: 29
Posted: Aug 26, 2011 - 03:35 PM
-
- Rank: Mate
- Registered: Jul 06, 2008
- Last visit: Jul 19, 2018
- Posts: 986
Posted: Aug 26, 2011 - 05:48 PM
put trax under side stays
loop line over bottom of stay
make a loop like your tying a shoe and pull through the end you just looped over the stay
pull snug but not overly so.
the loop should be in the bite so you can pull the tail to release it.
--
Dustin Finlinson • Magna, UT
Member: Utah Sailing Association
1982 Prindle 18
1986 Hobie 17
1982 Prindle 16
1980 Prindle 16(mostly)
1976 Prindle 16(mostly)
Check out "Prindle Sailors" on Facebook.
-- -
- Rank: Lubber
- Registered: Dec 25, 2010
- Last visit: Nov 26, 2011
- Posts: 29
Posted: Aug 26, 2011 - 10:12 PM
The placement seems like a better balance point. I have been mostly using the corners of the tramp to secure it. I however don't get your loop method. At least sitting here. It may make sense with a line and the boat in front of me.
--
The Bone
H16
Mass / NH
-- -
- Rank: Mate
- Registered: Nov 02, 2004
- Last visit: Aug 07, 2023
- Posts: 626
Posted: Aug 26, 2011 - 10:58 PM
It's a slip knot.
Wrap the line around the shroud. Put Your hand down thru the wrap and grab the middle of the end and pull it back up thru leaving a tail that you can pull which undose the knot.
--
Ron
Nacra F18
Reservoir Sailing Assn.
Brandon, Mississippi
-- -
- Rank: Lubber
- Registered: Dec 25, 2010
- Last visit: Nov 26, 2011
- Posts: 29
Posted: Aug 27, 2011 - 09:13 AM
Gotcha!!!
--
The Bone
H16
Mass / NH
--
Users on-line
This list is based on users active over the last 60 minutes.