beach Wheels
-
- Rank: Lubber
- Registered: Jun 03, 2009
- Last visit: Aug 11, 2020
- Posts: 7
Posted: May 21, 2012 - 09:29 AM
Sorry for this lame post. but can someone tell me the crrect order for the washers and bushings on the beach wheels, as I am replacing my plastic wheels with inflatable ones, Thanks in advance
-
- Rank: Mate
- Registered: Dec 18, 2009
- Last visit: Oct 10, 2019
- Posts: 117
Posted: May 21, 2012 - 11:33 AM
Cotter pin, metal washer, plastic washer, tire, put plastic bushings in tire, plastic washer, metal washer, cotter pin.
Edited by spoulton on May 21, 2012 - 12:34 PM.
--
Scott
ARC 21
Prindle 18
Annapolis, Maryland
-- -
- Rank: Mate
- Registered: Nov 02, 2004
- Last visit: Aug 07, 2023
- Posts: 626
Posted: May 21, 2012 - 11:36 AM
Plastic on inside so that cotter pin rest on metal.
--
Ron
Nacra F18
Reservoir Sailing Assn.
Brandon, Mississippi
-- -
- Rank: Lubber
- Registered: Jun 03, 2009
- Last visit: Aug 11, 2020
- Posts: 7
Posted: May 21, 2012 - 12:34 PM
Thank you that is what I thought but wasn't sure because they sent extra. -
- Rank: Mate
- Registered: Jul 06, 2008
- Last visit: Jul 19, 2018
- Posts: 986
Posted: May 21, 2012 - 01:09 PM
When I converted I had to drill a new hole on each side because the old style rims were wider at the center hub. It was also a pain to the get the second cotter pin in on each side due to the angle. I had to cut one of each down a very little bit. Also I sprayed a bunch of sailkote into the delrin bearings before reinstalling.
--
Dustin Finlinson • Magna, UT
Member: Utah Sailing Association
1982 Prindle 18
1986 Hobie 17
1982 Prindle 16
1980 Prindle 16(mostly)
1976 Prindle 16(mostly)
Check out "Prindle Sailors" on Facebook.
-- -
- Rank: Mate
- Registered: Dec 18, 2009
- Last visit: Oct 10, 2019
- Posts: 117
Posted: May 21, 2012 - 07:16 PM
I just put a used set together and had to reuse old bent stainless cotter pins. Helped to get them as straight as possible with a pair of pliers then squeeze ends together with a small piece of duct tape that exetended just beyond the cotter pin. This allowed me to shape the end of the duct tap to a point, makinging it easier to get the cotter pin throught the drilled holes.
--
Scott
ARC 21
Prindle 18
Annapolis, Maryland
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.