My adjustment screws for my I17 rudders are corroded in the casting, to a degree that I think I'll break them if I try to adjust them. So the rest of this is a bit hypothetical..
I need to rake my rudders back a touch. The feel like they want to pop off of center when they get a little loaded, like they're swept too far under the boat. Also, I can see a little wear on them where it looks like they've hit the transoms when being locked down.
However, even if I could move the adjustment bolts, it appears that they are tightened all the way already. Loosening them would increase the distance at the top of the rudder, and therefore sweep them even more.
How can I rake the back a bit?
Thanks!
--
Rob
OKC
Pile of Nacra parts..
--
Inter Rudder Adjustment
-
- Rank: Mate
- Registered: Aug 22, 2007
- Last visit: Jan 07, 2015
- Posts: 742
-
- Rank: Mate
- Registered: Jan 14, 2004
- Last visit: Sep 25, 2024
- Posts: 866
First time I heard this I was skeptical, but use Snobol to get it loose. Time and Snobol are your friend. Make sure to grease them when you put them back together.
--
Philip
-- -
- Rank: Mate
- Registered: Aug 22, 2007
- Last visit: Jan 07, 2015
- Posts: 742
-
- Rank: Mate
- Registered: Jan 14, 2004
- Last visit: Sep 25, 2024
- Posts: 866
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.