Welcome anonymous guest

Please Support
TheBeachcats.com

Replacing Mast Hound on Prindle 16  Bottom

  • Just picked up a 1976 Prindle 16 in fantastic shape...but completely disassembled. I am looking at the holes for the previous mast hound, and they do not match up with the new one I picked up. I want to make sure it is mounted in the right place on the mast, and was wondering if anyone had a measurement from the mast base to the bottom of the mast hound...I am sure I will have many other questions to come.
    Thanks for your help,
    Ty G Westfall
  • Be sure to plug the unused holes with silicone during assembly.
    You want that mast watertight when you capsize.

    --
    Sheet In!
    Bob
    _/)_____/)_/)____/)____/)_____/)/)__________/)__
    Prindle 18-2 #244 "Wakizashi"
    Prindle 16 #3690 "Pegasus" Sold (sigh)
    AZ Multihull Fleet 42 member
    (Way) Past Commodore of Prindle Fleet 14
    Arizona, USA
    --
  • You might consider plugging them a with rivet as well as silicone.



    Edited by Quarath on Aug 21, 2012 - 03:17 PM.

    --
    Dustin Finlinson • Magna, UT
    Member: Utah Sailing Association
    1982 Prindle 18
    1986 Hobie 17
    1982 Prindle 16
    1980 Prindle 16(mostly)
    1976 Prindle 16(mostly)

    Check out "Prindle Sailors" on Facebook.
    --
  • On my '83 mast it is 225 3/4" from the bottom of the base casting to the bottom of the hound.

    --
    Pete Knapp
    Schodack landing,NY
    Goodall Viper,AHPC Viper,Nacra I20
    --
  • I measured same.... icon_biggrin

    --
    TurboHobo
    H14T
    H16
    P18
    G-Cat 5.0
    P16
    --
  • Thanks a lot guys...I appreciate the help. I used to sail an old Alcort Catfish that I fully restored, so this is quite a jump up for me!

No HTML tags allowed (except inside [code][/code] tags)

  • Options

This list is based on users active over the last 60 minutes.

Upcoming Beachcats Events

VIEW FULL CALENDAR

No upcoming events.