I am purchasing a H18 and will need to get a new Tramp for it.
I am a novice and will either be solo, or crew of 2 to 3. Typically will be summer sailing in lower Chesapeake out of VA Beach.
My question is;
One piece bias cut tramp or
Or 3 piece standard Tramp?
I was planning on going with Mesh thinking that vinyl would get too hot and slick when wet.
Thanks for any suggestions and input.
--
Scott Webb
Virginia Beach - Sandbridge
Still looking for my first Cat
--
H18 Tramp Question
-
- Rank: Lubber
- Registered: Aug 29, 2012
- Last visit: Apr 19, 2013
- Posts: 6
Posted: Aug 31, 2012 - 08:49 AM
-
- Rank: Lubber
- Registered: Aug 29, 2012
- Last visit: Apr 19, 2013
- Posts: 6
Posted: Aug 31, 2012 - 08:51 AM
Should have also added that the H18 also has wings with mesh covers right now, in case that makes a difference.
--
Scott Webb
Virginia Beach - Sandbridge
Still looking for my first Cat
-- -
- Rank: Chief
- Registered: Apr 19, 2011
- Last visit: Dec 10, 2024
- Posts: 1461
Posted: Aug 31, 2012 - 09:35 AM
Mesh is my preference, and bias cut at that. The bias cut means you only have to tighten it along one edge, instaed of two or three. The only time I liked a solid vinyl tramp was ocean racing in big chop- the tramp was a sheild against the water coming in from below. A bias mesh tramp is pricey, and if $$$ is an issue, give tenara thread a priority over other features. The regular thread rots in a couple of years, but Tenara thread is a Teflon derivitive and can last a decade.
--
Sheet In!
Bob
_/)_____/)_/)____/)____/)_____/)/)__________/)__
Prindle 18-2 #244 "Wakizashi"
Prindle 16 #3690 "Pegasus" Sold (sigh)
AZ Multihull Fleet 42 member
(Way) Past Commodore of Prindle Fleet 14
Arizona, USA
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.