on my hobie 16' I bought upper adjustable castings. How do they work with the cams? Does the bar fit under the lip of the cam? if that's the case, how do I lock the slide plate to the weathered position I want?
--
Ed Lavin
Time on the water doesn't count on the clock of life
--
adjustable upper castings
-
- Rank: Lubber
- Registered: Sep 24, 2012
- Last visit: Mar 14, 2014
- Posts: 23
Posted: Mar 17, 2013 - 09:29 PM
-
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Oct 20, 2024
- Posts: 878
Posted: Mar 19, 2013 - 06:04 AM
There are also some great videos on youtube for Hobie rudder adjustments. I think someone posted a link on this site not to long ago -
- Rank: Mate
- Registered: Aug 01, 2002
- Last visit: Sep 14, 2024
- Posts: 425
Posted: Mar 20, 2013 - 11:48 AM
The plate catches in the notch on the cam just like the rolled pin does on non-adjustable castings.
Lock rudder down. Loosen slide plate and, using little force, push it forward as far as possible. Tighten slide plate. Make sure rudder locks down and kicks up properly. (Too far forward....may bind and not lock down. Too far back....may not engage cam/increases tiller load.)
The cams don't like to rotate when doing this "dry" on the trailer. Use some lubricant (white lithium grease, dishwashing soap, etc.) on the cam and plunger. Also....one of those Hobie mysteries.....a rudder that works perfectly on the trailer sometimes won't on the water. Be sure to check for proper on-the water operation before starting a trans-Atlantic crossing or Alter Cup.
--
Jerome Vaughan
Hobie 16
Clinton, Mississippi
-- -
- Rank: Lubber
- Registered: Sep 24, 2012
- Last visit: Mar 14, 2014
- Posts: 23
Posted: Mar 20, 2013 - 08:54 PM
Thank you both very much
--
Ed Lavin
Time on the water doesn't count on the clock of life
-- -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: May 22, 2024
- Posts: 7089
Posted: Mar 21, 2013 - 09:01 AM
rudder tips i remember from my h16 and 18:
get a hobie tool.
with the hobie tool, you can reset your cam (even on the water) if it has accidentally locked down without the rudder in place. without the tool .. you need to use a large flathead or similar and risk gouging your cam/plunger and is really hard to do on the water.
a rudder that wont lock down, or release when you hit ground is a bad thing and can take your attention away from sailing (and looking forward)...
i spray my cams with silicon weekly. I don't need to do it every day, but I squirt em each week, or if they got sandy
Edited by MN3 on Mar 21, 2013 - 09:03 AM. -
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Oct 20, 2024
- Posts: 878
Posted: Mar 21, 2013 - 04:32 PM
The tool works, but to be able to use it you first must drill a 3/16 hole on the flat side of the rudder cam. If you purchase a new tool the instructions should come in the package.
