Hi,
I have 1984 Hobie with rudder upgrade. One rudder kicks up at speed. I tightened adjusting screw all the way down and replaced the spring. The black plastic cam does not show signs of wear compared to the other one and the aluminum adjusting piece is in the same position as the other one. Any suggestions?
Lucydog11
Rudder kick up tension
-
- Rank: Lubber
- Registered: Jul 08, 2013
- Last visit: Jul 02, 2014
- Posts: 9
Posted: Aug 07, 2013 - 05:09 AM
-
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Oct 20, 2024
- Posts: 878
Posted: Aug 07, 2013 - 07:17 AM
Possibly hole alignment in the rudders, did you re drill after the adjustable rudder castings were installed. The holes are slightly different. -
- Rank: Administrator
- Registered: Jul 19, 2001
- Last visit: Nov 15, 2024
- Posts: 3446
Posted: Aug 07, 2013 - 01:01 PM
lucydog11, just to be sure, which model are we talking about? Hobie 16 or 18? If it's an 18 did you buy and install the whole upgrade kit from Hobie or piece it together?
--
Damon Linkous
1992 Hobie 18
Memphis, TN
How To Create Your Signature
How To Create Your Own Cool Avatar
How To Display Pictures In The Forums.
-- -
- Rank: Lubber
- Registered: Jul 08, 2013
- Last visit: Jul 02, 2014
- Posts: 9
Posted: Aug 07, 2013 - 02:39 PM
Thanks,
It is an 18. I did not install the upgrade. The rudders are black and only have one set of holes in them. I wrote the post after screwing the adjusting the delrin screw all the way in, one rudder still seemed to kick up easier than the other when I tested it manually in my garage. However I have just done the tension test with a scale and one kicks up at 22 lbs. and the other at 18 lbs. so by dialing the delrin screw all the way in, I may have improved it but I don't have the original reference point to compare to unless I unwind the delrin screw and re-test with the scale or do an in water sailing test. I also read David Hall's article "Towards the No Slop Rudder" and I will see if any of his suggestions fit. I'm also going to make sure the rudder locking plate is snug against the rudder cam lip. The good rudder has a nice solid click in while the other one is not so much.
Lucydog11 -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Dec 04, 2024
- Posts: 7090
Posted: Aug 07, 2013 - 05:15 PM
close enough
also silicone spray (lube) is your friend and will make a huge difference with sticking rudders - i spray mine every time i rig
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.