I just discovered that one of the two hull plugs (big white rubber blobs under the rear crossbar) is missing on my P16. Murray's offers something they claim is a replacement, although it's nothing but a conic rubber plug. It looks like somehting that's dying to fall right back out just like the old one did. I plan to get that anyway, then drill out the center and use one of those spreading drywall/masonry anchors to spread it inside the hole so it does not fall out again.
However, I am not sure how to make waterproof the hole I will need to make through the plug to let in the anchor screw. I of course plan to make the hole smaller than the screw so there will be SOME seal, but is it sufficient? Also, I wonder if that hole is even connected to the inside of the hull - is it a separate watertight compartment? In that case, I could run the boat with no plugs at all and not have any problems.
Any information/suggestions/opinions would be greatly appreciated.
--
Mike
Prindle 16
Rochester, NY
--
P16 hull plug lost
-
- Rank: Lubber
- Registered: Sep 24, 2013
- Last visit: Jan 25, 2023
- Posts: 57
-
- Rank: Mate
- Registered: Mar 12, 2003
- Last visit: Feb 19, 2021
- Posts: 879
Your last sentence is correct. For the last 30 years I just use a piece of duck tape over that very small compartment. Pete -
- Rank: Mate
- Registered: Sep 29, 2012
- Last visit: Jan 10, 2018
- Posts: 441
Hole is not connected, you can leave open, will collect some water, most will drain off. I tried those plugs from Murrays, dismal failure, one dropped out to be sacrificed to the sailing gods. -
- Rank: Lubber
- Registered: Sep 24, 2013
- Last visit: Jan 25, 2023
- Posts: 57
Thanks gents - that's $20 saved for some line replacement.
--
Mike
Prindle 16
Rochester, NY
-- -
- Rank: Mate
- Registered: Jun 26, 2009
- Last visit: Mar 20, 2015
- Posts: 150
These pockets may not supposed to connect through to the inside of the hulls but 2 of mine do. I had to retrieve a nut dropped into the pocket from the inside of the hull the when I took my crossbeams off last... That being said cover the holes with bumper stickers and sail on. -
- Rank: Lubber
- Registered: Sep 24, 2013
- Last visit: Jan 25, 2023
- Posts: 57
Yeah! Bumper stickers! Totally doing that! I will check if my hulls have connection to these pockets before hitting the waves.
Anyone wants to suggest cool cat sailing bumper stickers? Like a sailor cat or some such?
--
Mike
Prindle 16
Rochester, NY
-- -
- Rank: Lubber
- Registered: Sep 24, 2013
- Last visit: Jan 25, 2023
- Posts: 57
-
- Rank: Mate
- Registered: Aug 11, 2010
- Last visit: Mar 19, 2018
- Posts: 424
Users on-line
This list is based on users active over the last 60 minutes.