What are some of you P18 drivers using for your rudder rake setting..
Setup manual is saying 1/2" good starting point.. Anyone carrying more or less?
Yes I don know the mast rake is part of the set up procedure...
--
John Schwartz
Ventura, CA
--
Prindle 18 Rudder Rake
-
- Rank: Mate
- Registered: Sep 01, 2002
- Last visit: Oct 31, 2024
- Posts: 796
Posted: Jul 18, 2015 - 09:07 PM
-
- Rank: Mate
- Registered: Mar 12, 2003
- Last visit: Feb 19, 2021
- Posts: 879
Posted: Jul 18, 2015 - 09:16 PM
John, With the Tripoint race on the horizon, these are points some of us are not likely to divulge. Pete -
- Rank: Mate
- Registered: Mar 12, 2003
- Last visit: Feb 19, 2021
- Posts: 879
Posted: Jul 18, 2015 - 11:51 PM
But I will give you the statement from the Prindle Manual: Lower the rudders (on trailer) & lock down. Take a batten or yardstick & lay the straight edge flush against the transom. Adjust the lock bolt so that the forward bottom edge of the rudder is about 1/2" aft of the forward edge of the batten. (pull rudder back lightly to pull out any slop.) 1/2" aft is a good starting point, further adjustment may be necessary for personal preference. Somewhere I have an old Smyth tuning guide, tho can't find at moment. Pete -
- Rank: Lubber
- Registered: Jul 27, 2008
- Last visit: May 31, 2019
- Posts: 51
Posted: Jul 18, 2015 - 11:56 PM
Leave the rudders up and you should be good to go, John!!! See you at the Tri-Point Ocean Race!!! Bob Martinez -
- Rank: Mate
- Registered: Sep 01, 2002
- Last visit: Oct 31, 2024
- Posts: 796
Posted: Jul 19, 2015 - 10:26 AM
Gents...
Regarding the Tri-Point.... I am not going to be able to make it... I am in NYC and Philadelphia the whole week prior for meetings and don't get back to Los Angeles until late Friday night..
Pete... If you come across the Smyth Tuning let me know..
John
Edited by JohnES on Jul 19, 2015 - 10:27 AM.
--
John Schwartz
Ventura, CA
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.