My question is that I have downloaded the manual for the Prindle 16 and I appear to have some extra hardware that doesn't show up in the manual.
Here is how my rig lines are setup:
Prindle 16 jib rigging
-
- Rank: Lubber
- Registered: Jul 20, 2015
- Last visit: Oct 20, 2015
- Posts: 5
Posted: Jul 30, 2015 - 04:31 PM
Hello all, so I recently purchased a Prindle 16 and beyond the soft/cracking noises in the hull (which I will be fixing soon) this boat is great! I had her out on the water and she seems to sail great (once you figure everything out).
My question is that I have downloaded the manual for the Prindle 16 and I appear to have some extra hardware that doesn't show up in the manual.
Here is how my rig lines are setup:
-
- Rank: Mate
- Registered: Mar 12, 2003
- Last visit: Feb 19, 2021
- Posts: 879
Posted: Jul 30, 2015 - 06:21 PM
The red line (jib sheet) should be 2:1 by tying off at the becket on jib block, then going thru small block (pulley) attached to clew of sail (preferable by a foot long 1/4" line. And red line should be continuous lying on tramp, not two ends. Blue line (barber hauler ) is correct but only used going on a reach (not to weather). Red line should be about 26-30', blue line 20". Fix the deck before you break off a bow! Pete -
- Rank: Lubber
- Registered: Jul 23, 2014
- Last visit: Jun 05, 2024
- Posts: 11
Posted: Jul 31, 2015 - 09:15 PM
Here's how I've rigged my P18:
--
__
Nacra 5.7
Prindle 18
Trac 14
Crewed on Hobie 16 and 18, Dart 18, and Prindle 16
-- -
- Rank: Lubber
- Registered: Jul 20, 2015
- Last visit: Oct 20, 2015
- Posts: 5
Posted: Aug 02, 2015 - 10:58 PM
Thanks Pete! I will be fixing the hulls very soon. Do you recommend epoxy from West Marine or will the cheaper epoxy for Lowe's be fine? I've read a few reviews and everyone seems to like the West system because of the longer cure time.
Anahr: your lines are very nice. DI'd you tie the blue line back to the cleat or some over point? Where did you get the stainless rings? I really like that especially since you hardly use them.
Edited by konzekat on Aug 02, 2015 - 11:58 PM. -
- Rank: Lubber
- Registered: Jul 23, 2014
- Last visit: Jun 05, 2024
- Posts: 11
Posted: Aug 03, 2015 - 11:07 AM
Yes, I tied the ends of the job sheets to the top pin of the fiddle block/cleat.
This is the ring I got: http://www.baronusa.net/a…-x-1-1-2-6-x-40-mm-/1625
This place has a fantastic selection and amazing prices.
Edited by anahr822 on Aug 03, 2015 - 11:07 AM.
--
__
Nacra 5.7
Prindle 18
Trac 14
Crewed on Hobie 16 and 18, Dart 18, and Prindle 16
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.