Hi all, the rotation stops on the mast base of my P16 are pretty badly worn, so the mast swings a lot farther than intended. I may replace the base to fix it, but an alternate idea would be to install a rotation control arm. I don't know much about these. Can anyone offer an opinion on which solution to go for? And, if the control arm is preferred, which type? Thx
--
Paul
Prindle 16
"Nuissa"
--
Prindle 16 mast rotation
-
- Rank: Lubber
- Registered: Jul 21, 2014
- Last visit: Dec 14, 2020
- Posts: 11
Posted: Jul 26, 2016 - 08:17 AM
-
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Oct 20, 2024
- Posts: 878
Posted: Jul 26, 2016 - 08:49 AM
Easiest fix is to file stops so they are flat and at 90 degrees and then get a piece of SS the same size drill a hole in the center of the piece and screw into the stops
The mast base for a boat with mast rotation and one without are different the one for a mast rotation does not have any stops on it -
- Rank: Mate
- Registered: Sep 01, 2002
- Last visit: Nov 30, 2024
- Posts: 797
Posted: Jul 26, 2016 - 04:25 PM
The Prindle 18, 18-2, and 19 have a wishbone that attaches to the mast and rigs into the boom.. here is a pic of the rigging
I think the Hobie 17 & 18 use the same one.... but you nay have an issue finding one.... unless you already have one.
Personally I would go with a new mast base from Murrays... some silicone along with three rivets and your done... http://www.murrays.com/56-6005.html
Edited by JohnES on Jul 26, 2016 - 04:26 PM.
--
John Schwartz
Ventura, CA
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.