Hi All,
How do I separate hulls from the beams on a Hobie 17?
How much efforts, don't want to damage anything...
Ideas, photos, manuals etc. are very welcome.
BR
MCTG8
Hobe 17 - separate hulls from front and rear beams
-
- Rank: Lubber
- Registered: Aug 22, 2016
- Last visit: Jul 03, 2017
- Posts: 17
Posted: Aug 22, 2016 - 10:57 AM
-
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Dec 04, 2024
- Posts: 7090
Posted: Aug 22, 2016 - 11:17 AM
-
- Rank: Lubber
- Registered: Aug 22, 2016
- Last visit: Jul 03, 2017
- Posts: 17
Posted: Aug 22, 2016 - 11:29 AM
Thanks!
Goal is to check for any cracks and structural problems.
I've seen the attached manual, but is it really just one socket set screw + anchor bar per side and beam?
//MCTG8 -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Dec 04, 2024
- Posts: 7090
Posted: Aug 22, 2016 - 12:57 PM
I've owned a h16 and h18 but never a 17 ... i will leave it for actual owners to comment...
and i couldn't see clearly in that manual .. worst images ever (was it illustrated with stone and chisel?)
Some General Tips:
I would use penetrating oil ahead to assist of release
if the bolts squeak - stop don't heat em up - go slow
use a product on your bolts before you reassemble - i swear by Tef-Gel
Edited by MN3 on Aug 22, 2016 - 01:04 PM. -
- Rank: Lubber
- Registered: Aug 22, 2016
- Last visit: Jul 03, 2017
- Posts: 17
Posted: Aug 22, 2016 - 05:21 PM
Agree, hard to tell from the pictures. But OK, I understand how it's set up.
Users on-line
This list is based on users active over the last 60 minutes.