Where do I get a duplicate of this. Faint lettering reads ILSE, but not sure that is complete. It's from the Marstrom
2 mm thick, 48 mm hole0 spacing, 22.5 mm (.885 ") wide , 150 mm (6 inches) long , 1/4" holes
Photo in process
Edited by ctcataman on Nov 25, 2017 - 01:16 AM.
--
John
Nacra 5.0
CT
--
Shroud Anchor Plate
-
- Rank: Mate
- Registered: Nov 25, 2015
- Last visit: Jul 17, 2024
- Posts: 661
Posted: Nov 24, 2017 - 11:48 PM
-
- Rank: Mate
- Registered: Nov 25, 2015
- Last visit: Jul 17, 2024
- Posts: 661
Posted: Nov 26, 2017 - 09:37 AM
Edited by ctcataman on Nov 26, 2017 - 12:43 PM.
--
John
Nacra 5.0
CT
-- -
- Rank: Mate
- Registered: Nov 19, 2015
- Last visit: Oct 22, 2024
- Posts: 398
Posted: Nov 26, 2017 - 03:29 PM
Well good news if you cant find one it looks pretty simple to make. -
- Rank: Mate
- Registered: Nov 25, 2015
- Last visit: Jul 17, 2024
- Posts: 661
Posted: Dec 14, 2017 - 06:08 AM
The plate is doubled up and welded for the shroud pin. Fabricating a plate is easy, but I don't have a spot welder.
What places stock stuff like this? Johnson?
--
John
Nacra 5.0
CT
-- -
- Rank: Mate
- Registered: May 09, 2009
- Last visit: Aug 14, 2024
- Posts: 686
Posted: Dec 14, 2017 - 07:06 AM
I would try the place in the link that I added. Also that plate looks identical to the ones on my '76
sailcraft so I assume that it is somewhat of a standard piece. Maybe ask over on Tornadocat. Geoff
Dobbs might have some stashed away or someone may have a parts boat.
http://www.tornado-class.…supplied-by-cat-sailing/
--
Pete Knapp
Schodack landing,NY
Goodall Viper,AHPC Viper,Nacra I20
-- -
- Rank: Mate
- Registered: Mar 19, 2004
- Last visit: Nov 21, 2024
- Posts: 964
Posted: Dec 14, 2017 - 01:31 PM
All the spot weld does is hold the two pieces together and in alignment before the plate is installed. Once you put the top screw in, the smaller plate isn't going anywhere and the spot weld really doesn't do anything. If it really worried you, you could make the new plate out of a single piece of stainless strip that is the same thickness as the doubled up part you're replacing.
With a little spare time and a few basic hand tools, you could make replacement anchor plates very easily.
sm
Users on-line
This list is based on users active over the last 60 minutes.