Welcome anonymous guest

Please Support
TheBeachcats.com

Shroud anchors  Bottom

  • If I wanted to reinforce my shroud anchors would it make more sense to wrap glass from top of deck, under deck lip and then wrap a few inches onto hull sides where the anchor bar sits, or I could have some stainless hardware made similar to the upgrade people do to the Hobie 18 which will put some of the stress on the hulls instead of deck lip. Own both a Hobie 16 and a Gcat 5.7, thinking about doing it to both even though decks show no signs of failure. Boats are older and I push them pretty hard
  • I’d go with the H18 style option. On a Hobie 16, you could just weld a flat plate to the bottom of the shroud anchor bar so it sits flush against the hull sidewall. Then pop a couple holes in the plate and through the hull sidewall for 1/4” bolts and thru-bolt the plate to the hull. You might want to also throw a couple layers of glass mat inside the hull to beef up the sidewall where the bolts go through to help spread out the load.

    sm

No HTML tags allowed (except inside [code][/code] tags)

  • Options

This list is based on users active over the last 60 minutes.

Upcoming Beachcats Events

VIEW FULL CALENDAR

No upcoming events.