Does anyone know where I can get an aluminum rod matching the exact dimensions of the original? Don't need the hardware only the aluminum pipe. It's approx. 73 3/4" long x 1" Diameter and .120 Thickness. Thank you.
Prindle 16 Tiller Cross Bar
-
- Rank: Lubber
- Registered: Aug 24, 2016
- Last visit: May 29, 2018
- Posts: 1
Posted: May 29, 2018 - 10:35 AM
Well it looks like someone sat on my Tiller Crossbar while watching the sun set and snapped it in half.
Does anyone know where I can get an aluminum rod matching the exact dimensions of the original? Don't need the hardware only the aluminum pipe. It's approx. 73 3/4" long x 1" Diameter and .120 Thickness. Thank you. -
- Rank: Mate
- Registered: May 08, 2017
- Last visit: Oct 29, 2019
- Posts: 139
Posted: May 29, 2018 - 03:14 PM
Online metals has a wide range of tubing (lots of other stuff, as well). Their prices aren't bad, either, but shipping may be enough to call around for a local supplier.
https://www.onlinemetals.com/merchant.cfm?id=71&step=2&top_cat=60
It will be easier to find 1/8th-wall 1-inch tubing, and you also might look for a sleeve that you can rivet in. There's not a lot of load on the tiller crossbar unless someone uses it as a stool (frustrating, that!).
Randii -
- Rank: Mate
- Registered: Feb 05, 2011
- Last visit: Jun 15, 2021
- Posts: 575
Posted: May 29, 2018 - 03:31 PM
3/4" schedule 40 aluminum pipe has an od of 1.050. It sleeves right into 1" schedule 40. I bought a 20'-0" stick at my local metal supplier for about $35, and a 1'-0" piece from Online Metals
I made a tiller crossbar with material to spare.
--
'82 Super Cat 15
Hull #315
Virginia
Previously owned: '70 H14, '79 H16, '68 Sailmaster 26, '85 H14T
-- -
- Rank: Mate
- Registered: Oct 26, 2017
- Last visit: Sep 06, 2024
- Posts: 133
Posted: May 30, 2018 - 08:34 AM
I'm building a new crossbar myself. I'm using 1" 6061 aluminum that cost me $15 locally. I'm putting 7/8" delrin at the center and ends to strengthen where it will be drilled through. I've learned the hard way that 7/8" isn't always 7/8".
Where are you at? That might help others identify good sources of material for you.
--
Dana, Holly, Emma & Hannah
LJ/Stu's Dart 18 (Sold! :( )
-- -
- Rank: Lubber
- Registered: Feb 27, 2017
- Last visit: Feb 12, 2021
- Posts: 35
Posted: May 31, 2018 - 08:44 AM
Pipe and Tube are sized complementarily just for nesting.
--
Prindle 16
--
Users on-line
This list is based on users active over the last 60 minutes.