Adding a square hatch to Hobie16
-
- Rank: Lubber
- Registered: May 28, 2018
- Last visit: Aug 30, 2018
- Posts: 2
Posted: Aug 28, 2018 - 12:49 AM
I’ve been seeing these rectangular hatches to install in a Hobie, but so far only seeing where they’ve been installed in kayaks. Has anyone seen one installed in a Hobie cat? -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: May 22, 2024
- Posts: 7089
Posted: Aug 28, 2018 - 07:40 AM
i have 1 in my 5.5 and one in my 6.0
if i could do it all again - i wouldn't
they are flat on a curved huill and required a lot to get them to seat
they both leak water and i fear for the day i capsize on that hull -
- Rank: Mate
- Registered: Jul 01, 2016
- Last visit: Aug 30, 2023
- Posts: 631
Posted: Aug 29, 2018 - 12:33 AM
I wouldn't go cutting holes into Hobie 16 hulls, unless you absolutely had to, such as for access to the insides for repairs, but that's just me.
--
Marty
1984 Hobie 16 Redline Yellow Nationals, "Yellow Fever"
Opelika, Al / Lake Martin
-- -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: May 22, 2024
- Posts: 7089
Posted: Aug 29, 2018 - 07:59 AM
hobie 16's are notorious for delamination and somewhat known for hull failure forward of the beams where people add ports
probably the wrong boat unless adding hatches are needed to access the hulls -
- Rank: Lubber
- Registered: May 28, 2018
- Last visit: Aug 30, 2018
- Posts: 2
Posted: Aug 30, 2018 - 12:26 AM
Thank you for the input. I will heed your warnings.
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.