The spreader got out of square and collapsed during the mast raising (user error). I took it off and the tabs are twisted about 15 degrees. I pounded them nearly straight. No visible damage to welds. Is a smidge off ok on tab angle ? Thanks to all who have broken their boats before and are willing to chime in on this.
--
John
Nacra 5.0
CT
--
Spreader base tabs got bent
-
- Rank: Mate
- Registered: Nov 25, 2015
- Last visit: Jul 17, 2024
- Posts: 661
Posted: Jun 04, 2019 - 06:26 PM
-
- Rank: Mate
- Registered: Nov 25, 2015
- Last visit: Jul 17, 2024
- Posts: 661
Posted: Jun 05, 2019 - 09:12 AM
The real question is does hammer mechanics work here? -
- Rank: Mate
- Registered: Jun 17, 2011
- Last visit: Sep 24, 2023
- Posts: 783
Posted: Jun 05, 2019 - 10:15 AM
It would not bother me.
--
Greenville SC
Offering sails and other go fast parts for A-class catamarans
-- -
- Rank: Chief
- Registered: Apr 19, 2011
- Last visit: Dec 10, 2024
- Posts: 1461
Posted: Jun 05, 2019 - 06:24 PM
If you got the tabs close to eyeball straight, the important part now is to make sure the spreaders are 90 degrees to the mast. This may require you to bind them to the diamond wires with wire and then tape them. If you do this and then drastically change your diamond tension you may have to adjust.
--
Sheet In!
Bob
_/)_____/)_/)____/)____/)_____/)/)__________/)__
Prindle 18-2 #244 "Wakizashi"
Prindle 16 #3690 "Pegasus" Sold (sigh)
AZ Multihull Fleet 42 member
(Way) Past Commodore of Prindle Fleet 14
Arizona, USA
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.