I found that while sailing my P16 last weekend, my crew sat down and I heard the notorious crack associated with a soft spot. My question is simple.
What is the urgency of a soft spot and can it wait for winter? What are the cons of putting it off?
--
Joshua
Texas Gulf Coast
'82 Prindle 16 (Badfish)
'02 Hobie Wave (Unnamed Project)
‘87 Hobie 18 (Sold)
‘89 Hobie 17 (ill-advised project boat, Sold)
--
Soft Spot Urgency
-
- Rank: Mate
- Registered: Jan 17, 2019
- Last visit: Jan 13, 2020
- Posts: 216
Posted: Jun 10, 2019 - 12:22 PM
-
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: May 22, 2024
- Posts: 7089
Posted: Jun 10, 2019 - 01:56 PM
I wouldn't sail with a known soft spot
too much risk of catastrophic failure -
- Rank: Mate
- Registered: Mar 19, 2004
- Last visit: Nov 21, 2024
- Posts: 964
Posted: Jun 10, 2019 - 07:42 PM
It will only get worse (larger) the more it is stressed. A simple epoxy injection repair can be done in an afternoon. I would not put it off.
sm -
- Rank: Mate
- Registered: Jan 17, 2019
- Last visit: Jan 13, 2020
- Posts: 216
Posted: Jun 10, 2019 - 10:14 PM
Alright. Thanks for the input. I had hoped to put it off for a winter project to do right with paint and all but I think I need to heed the advice and just take care of it.
--
Joshua
Texas Gulf Coast
'82 Prindle 16 (Badfish)
'02 Hobie Wave (Unnamed Project)
‘87 Hobie 18 (Sold)
‘89 Hobie 17 (ill-advised project boat, Sold)
-- -
- Rank: Mate
- Registered: Jun 15, 2016
- Last visit: Apr 14, 2022
- Posts: 181
Posted: Jun 10, 2019 - 10:34 PM
Some considerations for the repair might include drilling many holes through the outer skin and foam (and not through inner skin); letting the inside really dry out well (lots of holes and sun); using West System epoxy and syringes (well worth the money). With the West System, I would use slow hardener and do the work in the morning, so the epoxy fills all voids before setting up. Mix small amounts in the container as large ones flash quickly, even with slow harder.
Edited by traphappy on Jun 10, 2019 - 11:37 PM. -
- Rank: Mate
- Registered: Jan 17, 2019
- Last visit: Jan 13, 2020
- Posts: 216
Posted: Jun 11, 2019 - 07:00 AM
I have seen instructions that have you inject the resin and then use screws to bring the layers together. How important is this or is it even necessary?
--
Joshua
Texas Gulf Coast
'82 Prindle 16 (Badfish)
'02 Hobie Wave (Unnamed Project)
‘87 Hobie 18 (Sold)
‘89 Hobie 17 (ill-advised project boat, Sold)
--
