Replacing dart 18 shroud plate
-
- Rank: Lubber
- Registered: Apr 24, 2020
- Last visit: Apr 24, 2020
- Posts: 2
Posted: Apr 24, 2020 - 04:44 PM
Working on my dart 18 today when in noticed that the port side shroud plate was loose. When I went to tighten up the screws, two out of three will not tighten. I assume there were nuts on the inside of the hull that have rusted out. I am afraid I will need to cut a hole in the deck to access and repair this. Anyone have any experience with this type of repair?
Users on-line
This list is based on users active over the last 60 minutes.