Hi All.
I have been fairing out my dagger boards that continually take a beating from sliding up and down in the dagger slots on a 1970's Sol Cat. I have a 2-part question in respect to making this go away.
Are there any mods/ideas out there on how to make the inside of the dagger board slot smooth, so that when the dagger gets lifted, it doesn't scratch? Maybe automotive truck bed-liner? any suggestions welcome.
Additionally, does anyone know of a particular brand clear coat that can be sprayed over the daggers/ rudders to give them an extra-tough finish.
I've faired them out, and will probably re-gelcoat them with some extra gel I have laying around. If possible I'd like to give them a coating of something rock-hard and abrasive resistant.
Thanks!
Fairing Dagger Boards
-
- Rank: Lubber
- Registered: Apr 27, 2008
- Last visit: Oct 31, 2008
- Posts: 18
Posted: Aug 06, 2008 - 03:49 PM
-
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: May 22, 2024
- Posts: 7089
Posted: Aug 07, 2008 - 10:54 AM
i glued some carpet on the tops of my slots... this was more to hold them in place that to avoid scratches... but could work -
- Rank: Lubber
- Registered: Apr 27, 2008
- Last visit: Oct 31, 2008
- Posts: 18
Posted: Aug 11, 2008 - 02:47 PM
Thanks. Could you upload a picture of the setup when you get a chance. I don't think it will work for my slots, but I'd love to see what you've got going on.
Reason being that my daggerboards are on a shock cord that pulls the top of them forward when in the up position. I don't think I have enough room there to put carpet and have the boards pinch forward.
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.