Prindle 19 daggerboard question
-
- Rank: Lubber
- Registered: Sep 25, 2008
- Last visit: Nov 18, 2008
- Posts: 7
Posted: Oct 03, 2008 - 12:30 PM
My daggerboards have a factory hole whichs lines up with a premolded channel when installed. Is there supposed to be some type of bolt or pin assembly to allow the daggerboards to pivot up in shallow water? I read the online user manual and I didn't find any mention of the daggerboards (centerboards)at all. If there are any P19/18 owners any advice would be helpful. It appears the boards will work fine without the pin.... -
- Rank: Lubber
- Registered: Mar 25, 2002
- Last visit: Nov 29, 2012
- Posts: 5
Posted: Oct 06, 2008 - 02:53 PM
The daggerboards pivot on a standard piece of 3/4" PVC pipe. They snap into some indents at the bottom of the channel you mentioned. The system works pretty nicely. If you need the exact length of the PVC, I think I have a set here somewhere.
Jack
Fort Loramie, Ohio
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.