|
I attached the Spinnaker pole as illustrated so it can easily be disconnected.
Date: 04/14/2004
Views: 3192
|
Be sure to seal rivets into mast to avoid leakage.
Date: 04/14/2004
Views: 2898
|
Spin halyard (Spin lock) can be settled onto the cross beam with epoxy putty. tap the screw holes into beam.
Date: 04/14/2004
Views: 2860
|
Support wires under the Furler.
Date: 04/14/2004
Views: 2658
|
|
Support the center of the Aluminum Spinnaker pole to stop flexing under loaded conditions.
Date: 04/14/2004
Views: 2736
|
Stainless 1.5in snuffer ring, riveted to 1.5in aluminum pole. The support wire connect to existing Hobie Hull hardware.The head
Stainless 1.5in snuffer ring, riveted to 1.5in aluminum pole. The support wire connect to existing Hobie Hull hardware.The head of the sail can be attached to the eyebolt so the sail load doesnt make the ring twist.
Date: 04/14/2004
Views: 2747
|
The finished snuffer bag is velcro'd onto the pole.
Date: 05/23/2004
Views: 3183
|
Flying with the new Spinnaker stuffed away.
Date: 11/16/2004
Views: 3128
|