|
Ready to roll
Date: 12/12/2002
Views: 545
|
I used Thule cross bars and saddles that I already had for my van.
Date: 12/11/2002
Views: 557
|
rear crossbar view
Date: 12/11/2002
Views: 479
|
Front support is easily removed from trailer in a couple minutes. All white parts are made from hard maple.
Date: 12/11/2002
Views: 448
|
|
Front support is held to trailer with 4 stainelss steel hose clamps (worm gear clamps)
Date: 12/11/2002
Views: 345
|
Base of front support showing notches where the hose clamps go.
Date: 12/11/2002
Views: 485
|
Another view of front mounting point
Date: 12/11/2002
Views: 323
|
Rear support, also made from hard maple. Traveller track is tilted back a few degrees so I mounted the kayak rack on a wedge to
Rear support, also made from hard maple. Traveller track is tilted back a few degrees so I mounted the kayak rack on a wedge to keep it vertical.
Date: 12/11/2002
Views: 598
|
|
The front board that locks onto the track is glued in place to the unit. The rear board is held in place with the two bolts, whi
The front board that locks onto the track is glued in place to the unit. The rear board is held in place with the two bolts, which go through the unit at a 45 degree angle. This locks the support very firmly to the track.
Date: 12/11/2002
Views: 578
|
Rear support
Date: 12/11/2002
Views: 473
|
|
|