|
IMG_2382
The winch I bought for $16 from Northern. It's a 3:1 with a 600 lb. capacity.
Date: 08/24/2011
Views: 1461
|
IMG_2383
The Gin pole which is made from a 10' piece of 1" steel pipe. I cut it approximately in half and coupled it together just below the bracket which holds the mast.
Date: 08/24/2011
Views: 1478
|
IMG_2386
I used 1" pipe clamps to hold the pipe to the mast upright. This allowed me to turn the lower section when joining the upper section to the bottom.
Date: 08/24/2011
Views: 1356
|
IMG_2387
The upper end of the gin pole. I used 3/8" eye bolts.
Date: 08/24/2011
Views: 1370
|
|
IMG_2385
This is the brace for the gin pole where it connects to the safety chain at the tongue. I use a turn buckle to tension it. This takes all the load and is a very necessary item.
Date: 08/24/2011
Views: 1457
|
IMG_2381
The 24" EPD tie down which connects to the trapeze wires on both sides and prevents side sway when raising and lowering.
Date: 08/24/2011
Views: 1540
|
IMG_2389
Mast step link which is needed, and works well.
Date: 08/24/2011
Views: 1316
|
IMG_2393
Here she is coming up.
Date: 08/24/2011
Views: 1440
|
|
IMG_2391
The rope from the winch is attached to the jib halyard which makes it easy to connect the main stay when she's up. I've left about 2' of the halyard out.
Date: 08/24/2011
Views: 1268
|
IMG_2384
And she's up. I can use the same rig to pull the boat out of the water, if I'm feeling weary, though that never requires a s much energy as stepping.
Date: 08/24/2011
Views: 1305
|
|
|