|
WP_20130816_006
Date: 08/17/2013
Views: 944
|
WP_20130816_005
The rubber band on the left is run through a block on the trapeze wire to pull the handle up when not in use.
Date: 08/17/2013
Views: 979
|
Setting up and testing the spin chute on the front lawn
Date: 05/20/2013
Views: 747
|
Finally got her back to the beach, with weights this time
Date: 05/20/2013
Views: 804
|
|
PA270002
forward areas reglassed and sanded.
Date: 12/08/2012
Views: 814
|
PA270001
rearmost areas reglassed and sanded. After these photos were taken the reglassed areas were painted twice and after sanding the whole right side of the hull painte 4 times with roller.
Date: 12/08/2012
Views: 838
|
PA060020
The backup piece in place. Next is to sand the rest of the core material away and laminate new core. I decided to sand it after the backup is in place, making the area stronger and also, the inside will not be full of dust.
Date: 10/06/2012
Views: 812
|
PA060019
One of the smaller dents. I sanded the outer skin away and laminated 2 layers. The darker middle part is still a bit low.
Date: 10/06/2012
Views: 808
|
|
PA050016
I laminated the backup piece on the plastick visible in the backround, so the backup has curvature to match the hull. The backup is made of 4 layers of 160 gram mat, I think 2 or 3 layers would have been quite enough for hole this size.
Date: 10/06/2012
Views: 819
|
PA050017
The backup in place and under tension. The 4 layer backup was quite hard to bend to get it through the hole.
Date: 10/06/2012
Views: 836
|
PA020009
Another view looking aft, the lighter part is the deck "cutout".
Date: 10/06/2012
Views: 782
|
PA020011
The middle bulkhead, looking forward of the hole. The hole was about 5 cm/ 2 inches in diameter, so I was able to check the wall from inside with a mirror, but my camera did not fit inside all the way.
Date: 10/06/2012
Views: 838
|
|
PA020008
I decided to make a hole and a patch behind in the largest damage area. Here is a view from the inside, looking aft. As you see there are plastic bags inside the hull, so a access hole on the topside would have been useless.
Date: 10/06/2012
Views: 878
|
200920121238
One hull barely fits to the garage
Date: 09/23/2012
Views: 876
|
230920121240
Grind the glassfibre and relaminate? Or make a hole, laminate packing, core and new glass on top?
Date: 09/23/2012
Views: 1003
|
230920121241
A slightly lighter area is soft
Date: 09/23/2012
Views: 784
|
|
230920121242
Another grind the glassfibre and relaminate? Or make a hole, laminate packing, core and new glass on top?
Date: 09/23/2012
Views: 823
|
230920121244
The biggest hit was here. I have taken out some core material, so the outer edges of inner skin are solid. Wondering if I could relaminate on the existing inner skin, or does it need to be removed and a new backing made?
Date: 09/23/2012
Views: 808
|
P9060008
Did not tie it down...
Date: 09/23/2012
Views: 1046
|
|