|
DSCF1664
More glass work including fairing, filling of aluminum trampoline extrusion holes, sanding etc in preparation of touch up painting.
Date: 11/23/2013
Views: 936
|
DSCF1663
After re-attaching deck section at hull/deck joint the deck tears have been reglassed with 3 layers of glass cloth including a layer of carbon fiber.
Date: 11/23/2013
Views: 851
|
DSCF1660
Original equipment side stay anchor system. Rod goes below hull deck joint. Short length and hull/deck glue may have contributed to failure.
Date: 11/16/2013
Views: 924
|
DSCF1661
Mixed polyester thickened with fibers to fill the gap between the hull deck joint. Clamped till resin hardens. Any voids in joint can be repaired later.
Date: 11/16/2013
Views: 827
|
|
DSCF1659
Missing deck is from behind main beam anchor location to about six feet back
Date: 11/16/2013
Views: 815
|
DSCF1656
Direct view of missing deck area. Inside of joint area was built up with chopped strand to help fill gap. This is also the area that the thickened resin was applied to.
Date: 11/16/2013
Views: 843
|
DSCF1657
Strengthening of inner hull and missing hull lip with layers of fiberglass cloth and carbon fiber. An aluminum plate of 3" by 4" was placed as well in case there is a need to use a chain plate instead of the typical side stay anchor rod.
Date: 11/16/2013
Views: 806
|
DSCF1655
Deck area to be reattached. Manufacturere used a gap filling material, maybe 'elephant snot' to bond the deck to the hull.
Date: 11/16/2013
Views: 833
|
