|
gin pole 001
Gin pole used on F18HT, which is a little odd, as this mast is raised opposite of most cats, which have the mast laying aft across the tramp. But this one benefitted from having the ability to lay the mast in the trailer's mast cradle to begin. Like all
Date: 07/11/2014
Views: 1899
|
gin pole 002
shows the initial position for raising. Note that with this pole the mainsheet is used for purchase, it's secured at the pole tip, and tied to the center of the rear beam.
Date: 07/11/2014
Views: 1554
|
gin pole 003
shows pole position when mast is raised, once the mast is near vertical the mainsheet runs out of travel, but you can just reach up and grab the pole and pull it down by hand the rest of the way. Tie off temporarily while securing the two side shrouds.
Date: 07/11/2014
Views: 1467
|
R21 gin pole 001
This pole is used on a Reynolds 21, the cradle at the mast has a pin that goes all the way thru the cradle and mast, very secure. A trailer winch is bolted to the gin pole just fwd of the mast.
Date: 07/11/2014
Views: 1324
|
|
R21 gin pole 002
A sturdy blk is bolted to the pole tip, that the line/cable from the winch runs thru. On this boat it hooks to a ss ring at the intersection of the bridle wires. The forestay is knocked into the pole tip. As the line is winched in, the
mast...
Date: 07/11/2014
Views: 1446
|
R21 gin pole 003
Another angle.
Date: 07/11/2014
Views: 1091
|
R21 gin pole 003ee
Pole tip detail.
Date: 07/11/2014
Views: 1288
|
IMG_0371
This pole was built for a SC20. The cradle is constructed of 4 or 5 pcs of 3/4" plywood, cut to the mast profile, and laminated together and lined with some insolite foam. It has a small line that wraps around the mast and ties off to a small clea
Date: 07/11/2014
Views: 1548
|
