Apparently the office for Performance has closed in Santa Ana, and Murray's doesn't have one. As noted, the P-19 and P-18-2 use the same front beam.
The boat and I are in the Morro Bay, CA area.
Thanks, Steve
that flat stainless strap? Perhaps you could contact a local shop with the measurements?
No, it's a 1-3/8 x 1/4 anodized heat treated bar. But I did decide to replace it with a stainless (304) of about 60% cross section. The old one fatigued, not corrosion. So, I'm feeling the warm fuzzies about this.
Thanks for your input, Steve
Anyone have a spare Prindle 19 port hull?
see attachment:
Ah, the Front Fell Off.
I believe this is becoming common
You should tow it out beyond the environment.
I have a good one in Florida- been in fresh water but not used for last 20 years. Stock anodized Al on intact, good uncorroded P19 front crossbar.